专用中央供料系统风机故障排除方法

专用中央供料系统风机故障排除方法：
专用中央供料系统风机故障排除方法如发现温度升高，它的原因有如下几点：
1、环境温度增高——增加环境通风散热。
2、工作状态改变——调整工作状态；
3、轴承干润滑——加轴承油脂；
4、风机效率降低——**叶道尘埃或更换泵头；
5、进气口温度过高——降低进气口温度；
专用中央供料系统风机故障排除方法如出现震动增大，它的原因有如下几点：
1、工作状态进入湍震区——调整工作状态，避开湍震区；
2、主轴变形——更换主轴或泵头；
3、叶轮不平衡——**叶轮中异物或校动静平衡；
4、轴承损坏——更换轴承；
专用中央供料系统风机故障排除方法如出现噪音增大，它的原因有如下几点：
1、轴承干润滑——加轴承油脂；
2、轴承损坏——更换轴承；
3、叶轮磨损——更换叶轮或泵头；
4、坚固件松动或脱落——拧紧紧固件；
5、风机内有异物——**异物或更换泵头。
5、进出气口进滤网堵塞——清洗过滤网。
专用中央供料系统风机故障排除方法如发现风机不转动，它的原因有如下几点：
1、未接通电源——接通电源；
2、电机不工作——检查电机接线或更换电机；
3、风机头损坏——修复风机或更换；
4、风机中有异物卡死——**异物Dedicated central feeding system fan troubleshooting method:
one,. If the temperature is found, it has the following reasons:
1, the ambient temperature increases - increase the environment ventilation cooling.
2, working state change - adjust the working state;
3, bearing dry lubrication - plus bearing grease;
4, reduce the efficiency of the fan - remove the leaf dust or replace the pump head;
5, the inlet temperature is too high - to reduce the inlet temperature;
Second, if there is increased vibration, it has the following reasons:
1, the working state into the turbulent area - to adjust the working state, to avoid the turbulent area;
2, spindle deformation - replace the spindle or pump head;
3, the impeller imbalance - remove the impeller in the foreign body or school static balance;
4, bearing damage - to replace the bearing;
Third, if the noise increases, it has the following reasons:
1, bearing dry lubrication - plus bearing grease;
2, bearing damage - replacement of bearings;
3, impeller wear - replace the impeller or pump head;
4, the firmware loose or off - tighten the fasteners;
5, foreign body in the fan - to clear the foreign body or replace the pump head.
5, into the air inlet into the filter plug - cleaning filter.
Four, if the fan does not turn, it is the following reasons:
1, not connected to power - connected to power;
2, the motor does not work - check the motor wiring or replace the motor;
3, the fan head damage - repair fan or replacement;
4, the fan has a foreign body stuck - remove foreign body